Canon Printer Error Code 5b00 - How to fix

Canon Printer Error Code 5b00 - Error code 5b00 is a very common problem that often occurs with Canon printers. While you turn it on and try to print a document, you will first notice that the printer starts normally.

Canon Printer Error Code 5b00 - How to fix


However, printing or scanning a document is no longer possible. The lamp will start flashing green and orange a few times in a row. However, make sure that this article helps you. Error 5b00 usually indicates a situation where a user cannot print due to the improper use of the ink cartridge.

In the following section, we have provided some of the best possible solutions to the problem. Just follow them carefully to avoid other problems.


What can I do if Canon printer error 5b00 is displayed?

1. reset the waste ink counter.

First, unplug the power cord and USB cables from the printer.

Open the cartridge door and press the power switch.

Continue to hold the power switch while plugging the power cord into the power outlet.

Press and hold the power button until the printer resets itself.

Once all the lights are on, you can release it.

Wait until the green power indicator goes off.

Then press the on / off button twice briefly.

The green light should continue to flash for a few seconds and eventually stabilize.

Close the cartridge door and try printing again.

The 5b00 error is often caused by spilled ink on your printer. The same is true for a full ink absorber or a full waste ink counter. Therefore, reset the ink absorber. You can actually use this quick fix to eliminate many error codes that can occur when you turn on the printer.


2. clean the waste ink pad manually

Open the ink cartridge compartment. Depending on the Canon printer model you are using, this compartment may be located at the front or back of the machine.

Wait for the ink cartridges to move completely.

Next, unplug the printer's power cord.

There is a row of white rollers behind the cartridge. Look for a small square near the roller that looks like a foam pad.

You will need to remove the waste ink absorber by gently pulling on its rubber frame.

Clean it with a paper towel. Try to collect all the waste ink on pieces of paper towel.

Reinstall all cartridges.

Install the frame back into the printer.

You can now hold down the power button and reconnect the power cord.

Release the button when the printer turns on.

Wait five seconds and press the power switch again. This will reset the printer's internal memory and overwrite the 5b00 error code.

If the problem persists, you can follow the steps above to fix it. When these waste ink pads become saturated, the printer will notify you with an error message like yours. Don't panic, because manual cleaning often works like a charm.


You can also use a bucket of soapy water. Just let the waste ink absorber soak until the ink comes off before reattaching the foam pads and installing the waste ink.

3. other possible solutions

If the printhead is not clean, this can often lead to this error. Check your printhead properly and make sure it is clean as well.

Also check the ink level of the system. If the ink level is low, you have no option but to fill it to maximum capacity.

Continue troubleshooting by resetting the printer to factory settings.

These are some remedies that can fix Canon printer error 5b00. Apply the above steps and let us know if they worked for you as well.


If you have any other questions or suggestions, feel free to leave them in the comment section below.

Previous
Next Post »
Comments


EmoticonEmoticon